Equipment features:

The drying oven is made of welded steel and thin plates, with a reasonable structure, beautiful box shape, sturdy and durable. It can be used as a test shelf and trolley in the workshop, and a good insulation layer is filled between the workshop and the box shell. Opening the air vent valve can allow the air in the studio to be refreshed.

Scope of application:

Drying oven is used for drying polymer materials, resin curing, pharmaceuticals, baking paint, electronics, electroplating, pharmaceuticals, printing baking, motor drying, transformer drying, industrial heat treatment, disinfection, heating, insulation and other process equipment in factories and research institutions.

Matters needing attention:

1. Place the drying oven horizontally in a non corrosive gas drying chamber.

2. The power input terminal should be equipped with a dedicated front-end on-off switch and properly grounded.

3. Check the power supply voltage and ensure that the power wiring is correct before powering it on for use.

4. When newly purchased or stored for a long time, it is recommended to first bake at low temperature (80-100 ℃) for two hours before starting to increase the temperature to facilitate moisture leakage, enhance menopausal performance, and prolong the lifespan of the ceramic.

5. The thermal sensor probe for instrument temperature control should be inserted into the working chamber from the temperature measurement hole on the left circuit layer, and should not be inserted from the top air valve of the box to avoid affecting use.

6. The drying oven has a good baking effect. When using it for the first time, please observe it frequently to avoid overheating and damaging the worker, causing losses.

7. If you feel a slight increase in thermal inertia during use, you can turn off a set of heaters to reduce the heating power and prevent overheating caused by excessive inertia.

8. Take out the baking object and do not hit the temperature controller part that extends into the studio to prevent damage to the temperature controller and malfunction.

9. If there is a malfunction, please have a professional electrician repair it.

10. At the time of leaving the factory, one copy of each of the two instruction manuals and certificates of conformity for the workshop shelf.

11. This oven should avoid baking explosive, flammable, and flammable materials to prevent explosions.